When you can hear some rattle from you bracelet here is the solution.

We start with some tools and masking tape.

Then we check the gap between the endlink and the case.

And then I bend it back.

There we have the problem, so now we have to take care of it.

So I start to push in the springbar.

After that I just pull it out from the case.

Then I pull out the springbar and then I have it in 3 pieces.

Now when we look at the endlink so can we see the

ears at the upside is just straight.

So I put on a little masking tape.

And then I bend it a little with the tongs at the both sides.

After that it looks like this.

Then I put some masking tape at the backside of the lugs.

Now it´s time to put the bracelet together and put it back at the watch.

So I put the endlink between the lugs from the backside and then I put one

side of the springbar at the case hole.

Then I use the springbar tool to press the springbar inside the endlink

until it jump in at the watch case.

Then I press down the endlink until I hear a click when the springbar is in place.

When I have check so the spring bar is in place at the both sides so

can I start use the watch again without some rattle.